To run Firewall Client unattended setup

• At a command prompt on the Firewall client computer, type:

  Path\Setup /v"[SERVER_NAME_OR_IP=ISA_Server_Name] [ENABLE_AUTO_DETECT={1|0}] [REFRESH_WEB_PROXY={1|0}] /qn"

  where:

  • Path is the path to the shared ISA Server 2006 client installation files. These files are usually located in a folder on the ISA Server computer with the share name ISA\MSPclnt.
  • ISA_Server_Name is the name of the ISA Server computer to which the Firewall client should connect.
  • ENABLE_AUTO_DETECT=1 specifies that the Firewall client should automatically detect which ISA Server computer to connect to.
  • REFRESH_WEB_PROXY=1 indicates that the Firewall Client configuration should be updated with the Web proxy configuration specified on the ISA Server computer.

Notes

• To run unattended uninstallation, type the following at a command prompt:

  MsiExec.exe /X {199B7F78-69B7-47C5-8D4B-A3ED1391FB6B} /qn

• To perform this procedure, you must be a member of the Administrators group on the client computer.
• You cannot install Firewall Client software on the ISA Server computer.
• Upon installation, the Firewall Client application is enabled.
• You can install Firewall Client software on client computers running Microsoft Windows Server 2003, Windows 2000 Server, Windows NT Server 4.0, Windows XP, or Windows Millennium Edition. You can also install Firewall Client software on computers running Windows 98 Second Edition with Microsoft Internet Explorer 5 or later installed.
• To allow client computers to access the Firewall Client Share, the Firewall Client Installation system policy configuration group must be enabled. This configuration group is enabled by default when you install the Firewall Client Share.

---

Get latest ISA Server content at ISA Server Guidance. Send feedback about this page.

• English-to-Russian translation