EAP authentication configuration

If you create a virtual private network (VPN) remote site network that uses a Point-to-Point Tunneling Protocol (PPTP) connection, and select Extensible Authentication Protocol (EAP) as its authentication protocol, you must complete the EAP configuration. EAP configuration is done using Routing and Remote Access.

To complete the EAP configuration, do the following:

  1. In the Routing and Remote Access Microsoft Management Console (MMC) snap-in, select the Network Interfaces node.
  2. When you applied the changes to the Microsoft Internet Security and Acceleration (ISA) Server 2006 configuration, a demand dial interface with the same name you gave the network was created. Select this demand dial interface, and then click Properties.
  3. On the Security tab, the advanced custom settings option should be selected. Click Settings to open Advanced Security Settings.
  4. Select the EAP you will be using, and then click Properties to configure EAP according to your EAP provider.

Note




web link Get latest ISA Server content at ISA Server Guidance.
Send feedback about this page Send feedback about this page.