To configure additional tunnel endpoints for
the remote site (Enterprise Edition)
ISA Server 2006 Enterprise Edition only
In the console tree of ISA Server Management, click
Virtual Private Networks (VPN):
Expand Microsoft Internet Security and Acceleration
Server 2006, expand Arrays, expand
Array_Name, and then click Virtual Private
Networks (VPN).
In the details pane, click the Remote Sites tab, and
then select the applicable remote network.
On the Tasks tab, select Configure Remote
Site.
On the Remote NLB tab, click Add Range.
In Start address, type the first address in the range.
In End address, type the last address in the range.
Note
To open ISA Server Management, click Start, point to
All Programs, point to Microsoft ISA Server, and then
click ISA Server Management.
Important
If the remote gateway is an array with Network Load Balancing
(NLB) enabled, you must specify all the dedicated IP addresses in
this procedure. Do not specify the virtual IP address.
Get latest ISA Server
content at ISA Server
Guidance(http://www.microsoft.com/).
Send
feedback about this page.